- Coronary Intervention
- Peripheral Intervention
- Vessel Closure
- Carotid Intervention
- Structural Heart
- Humanitarian Use Device
Hi-Torque Supra Core Peripheral Guide WireIndications & Important Safety Information ›› IFU (Full Version) ››
Steerability and support in a .035" peripheral guide wire
- One-to-one torque response designed for exceptional steerability
- Proximal .025" outer diameter designed for .035" compatible device exchanges
- MICROGLIDE coating provides lubricity designed for superb trackability
- Radiopaque tip designed for visibility during guide wire placement
- Supportive 035" shaft facilitates catheter placement for diagnostic and cross-over interventions
- Soft shapeable tip
|Stock number||Wire size |
AP2937656-US Rev. A
Indications and Important Safety Information
Hi-Torque Supra Core® 35 Guide Wire
Hi-Torque Supra Core 35 Guide Wires are intended to facilitate the placement and exchange of interventional devices during diagnostic or therapeutic interventional procedures.
Refer to the device label for any additional product specific indications which may apply.
The Hi-Torque Supra Core 35 Guide Wire is not intended for use in the
cerebral vasculature. Refer to the device label for any additional product specific contraindications which may apply.
This device is designed and intended for ONE TIME USE ONLY. DO NOT RESTERILIZE AND / OR REUSE. Observe all guide wire movement in the vessels. Before a guide wire is moved or torqued, the tip movement should be examined under fluoroscopy. Do not torque a guide wire without observing corresponding movement of the tip; otherwise, vessel trauma may occur.
Torquing a guide wire against resistance may cause guide wire damage and/or guide wire tip separation. Always advance or withdraw the guide wire slowly. Never push, auger, withdraw or torque a guide wire which meets resistance. Resistance may be felt and / or observed under fluoroscopy by noting any buckling of the guide wire tip. Determine the cause of resistance under fluoroscopy and take any necessary remedial action.
If the wire tip becomes entrapped within the vasculature, DO NOT TORQUE THE GUIDE WIRE.
Maintain continuous flush while removing and reinserting the guide wire to prevent air from entering the catheter system. Perform all exchanges slowly to prevent air entry and / or trauma. Wipe the wire before all exchanges.
When reintroducing the guide wire, confirm that the interventional device tip is free within the vessel lumen and not against the vessel wall. Failure to do so may result in vessel trauma upon guide wire exit of the device. Use the radiopaque marker of the interventional device to confirm position.
Guide wires are delicate instruments and should be handled carefully. Prior to use and when possible during the procedure, inspect the guide wire carefully for bends, kinks, or other damage. Do not use damaged wires. Using a damaged wire my result in vessel damage and / or inaccurate torque response.
Confirm the compatibility of the guide wire diameter with the interventional device before actual use.
Free movement of the guide wire within the interventional device is an important feature of a steerable guide wire system because it gives the user valuable tactile information. Test the system for any resistance prior to use. Adjust or replace the hemostatic valve with an adjustable valve if it is found to inhibit guide wire movement.